A Viking stove is a high-end appliance known for its durability and performance. If you own a Viking stove, you want to keep it in good working condition to last for many years.
One part of the stove that may eventually need to be serviced is the igniter. The igniter is what creates the spark that lights the gas burner. There are typically two igniters per burner on a Viking stove. One igniter is responsible for lighting the pilot light while the other igniter lights the main burner. However, it can become worn out or damaged over time and need to be replaced. When you need Viking Appliance Repair in Palmdale, especially when replacing the igniter, you can trust Viking Appliance Repairs for the job!
If you need to replace a Viking stove igniter, you should know a few things. This article will give you tips on effectively replacing a Viking stove igniter. Thanks to our industry-leading expertise in Viking Stove Repair, we can provide you with step-by-step instructions on replacing your Viking stove’s igniter.
Tools You Need:
- Flathead screwdriver
- Phillips head screwdriver
- Torx head screwdriver (optional)
- Pliers
- Needle nose pliers (optional)
Here are some tips on how to effectively replace a Viking stove igniter:
Step One: Disconnect the power to your stove. You will want to do this by unplugging the stove from the wall outlet or shutting off the circuit breaker that powers your stove. And this is an important safety precaution as you will be working with electrical components.
Step Two: Then, remove the burner grates and drip pans. Set them aside in a safe place. Next, locate the screws that hold down the control panel. Remove the screws using a Phillips head screwdriver, and once the screws are removed, lift the control panel to remove it.
Step Three: With the control panel removed, you will now access the igniters. Each igniter is attached to the stove with two screws. Use a flathead screwdriver or a Torx head screwdriver to remove the screws.
Step Four: With the screws removed, you can now pull out the old igniter and replace it with a new one. Make sure that you line up the new igniter in the same position as the old one. Screw the new igniter using either a flathead or a Torx head screwdriver.
Step Five: Then, replace the control panel and screw it back into place. Return the burner grates and drip pans. Please turn on the power to your stove and test the igniters to ensure they are working properly.
Replacing a Viking stove igniter is a relatively simple process. However, if you are not comfortable working with electrical components, we recommend you call us to do the job for you!